Installation of trimmer head
LEEJack
Before replacing the haymaker head, you need to make preparations to ensure that your operating environment is clean and tidy, and that it will not affect your work efficiency or damage your equipment. Preparation work includes:
1. Turn off the haybeater and place it on a flat surface.
2. Remove the spark plug from the haystack. This will prevent the weed whacker from igniting unintentionally.
3. Check the cutting head to see if it needs to be replaced. If it needs to be replaced, have a new cutting head on hand.
Removing the original cutting head
You will need to disassemble the head accordingly for different lawn mower models. However, most models have similar disassembly procedures.
1. Remove the haystack head from the cover. On some models, you will need to remove the cover before you can remove the beater head.
2. Open the new cutting head and remove the old cutting line. Be careful not to lose the old cutting line as it will be needed when installing the new cutting line.
3. Check the fasteners on the haystack head. If the fasteners appear to be loose, you will need to use a wrench or wrench to tighten them.
Install the new cutting head
To install the new cutting head you need to follow the steps below:
1. Locate the cutting line socket on the new cutting head. The socket is usually between the two semi-circular blades of the cutting head.
2. Insert the new cutting line into the socket on the cutting head. Note that the insertion should not exceed the length of the cutting head.
3. The upward-facing end of the cutting wire should pass through the hole and be secured to the cutting head.
4. Make sure the cutting wire is firm and not loose, and use a wrench to refasten the cutting head.
Testing the new cutting head
Before using the new cutting head, it is recommended that you conduct some tests to ensure that it works well and is safe. You can follow the steps below to test it:
1. Start the engine of the haymaker.
2. Gently hold the cutting head close to the lawn to make sure it works properly.
3. Confirm that the cutting head cuts well and the length of the cutting line is as required.